Good to know. I didn't it much in SXH, just installed SXH enough long enough to see the command was there. We had a multi-VRF deployment and SXH crashed and went to ROMMON once we configured 3 or more EIGRP AS #s in VRF-Lite deployment. We had to go to SXI for stability with EIGRP and VRF-lite. Then we lost Netflow commands again outside the global VRF.
Mike -----Original Message----- From: Phil Mayers [mailto:[email protected]] Sent: Wednesday, April 01, 2009 12:41 PM To: Mike Louis Cc: Jared Mauch; Tassos Chatzithomaoglou; cisco-nsp Subject: Re: [c-nsp] SXI1 is out Mike Louis wrote: > SXI didn't support Netflow export from a VRF other than the global table. The > command option wasn't available in the ip flow export command syntax. > > Here is what I am seeing in SXI > > 6509(config)#ip flow-export destination 10.1.1.3 9996 ? > <cr> > > The vrf flag was available in SXH. It didn't work properly in SXH. It only exported MSFC-switched flows. > > Has that been fixed in SXI1? > Note: This message and any attachments is intended solely for the use of the individual or entity to which it is addressed and may contain information that is non-public, proprietary, legally privileged, confidential, and/or exempt from disclosure. If you are not the intended recipient, you are hereby notified that any use, dissemination, distribution, or copying of this communication is strictly prohibited. If you have received this communication in error, please notify the original sender immediately by telephone or return email and destroy or delete this message along with any attachments immediately. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
