netflow on the 65xx is broken enough i'm surprised it gave you any
data of value.
- jared
On Apr 1, 2009, at 12:42 PM, Mike Louis wrote:
Good to know. I didn't it much in SXH, just installed SXH enough
long enough to see the command was there. We had a multi-VRF
deployment and SXH crashed and went to ROMMON once we configured 3
or more EIGRP AS #s in VRF-Lite deployment. We had to go to SXI for
stability with EIGRP and VRF-lite. Then we lost Netflow commands
again outside the global VRF.
Mike
-----Original Message-----
From: Phil Mayers [mailto:[email protected]]
Sent: Wednesday, April 01, 2009 12:41 PM
To: Mike Louis
Cc: Jared Mauch; Tassos Chatzithomaoglou; cisco-nsp
Subject: Re: [c-nsp] SXI1 is out
Mike Louis wrote:
SXI didn't support Netflow export from a VRF other than the global
table. The command option wasn't available in the ip flow export
command syntax.
Here is what I am seeing in SXI
6509(config)#ip flow-export destination 10.1.1.3 9996 ?
<cr>
The vrf flag was available in SXH.
It didn't work properly in SXH. It only exported MSFC-switched flows.
Has that been fixed in SXI1?
Note: This message and any attachments is intended solely for the
use of the individual or entity to which it is addressed and may
contain information that is non-public, proprietary, legally
privileged, confidential, and/or exempt from disclosure. If you are
not the intended recipient, you are hereby notified that any use,
dissemination, distribution, or copying of this communication is
strictly prohibited. If you have received this communication in
error, please notify the original sender immediately by telephone or
return email and destroy or delete this message along with any
attachments immediately.
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
