Thanks Ziv... Exactly what I was looking for as well! Try it out after I unpack my equipment after moving to the new house.
-Jeff ________________________________________ From: [email protected] [[email protected]] On Behalf Of Ziv Leyes [[email protected]] Sent: Thursday, May 21, 2009 2:11 AM To: 'Cisco-nsp' Subject: Re: [c-nsp] OT: 871W config This is a config sample of I'm using at home and it's working great, of course you need to change some of the settings to match your needs. ! bridge irb bridge 1 protocol ieee bridge 1 route ip ! interface FastEthernet0 ! interface FastEthernet1 ! interface FastEthernet2 ! interface FastEthernet3 ! interface Dot11Radio0 description WLAN no ip address ip virtual-reassembly load-interval 30 ! broadcast-key vlan 1 change 45 ! ! encryption vlan 1 mode ciphers tkip ! ssid MY-SSID-NAME vlan 1 authentication open authentication key-management wpa guest-mode wpa-psk ascii my-wpa-psk-key ! speed basic-1.0 2.0 5.5 6.0 9.0 11.0 12.0 18.0 24.0 36.0 48.0 54.0 station-role root no keepalive dot1x reauth-period 60 no cdp enable ! interface Dot11Radio0.1 description WLAN encapsulation dot1Q 1 native no cdp enable bridge-group 1 bridge-group 1 subscriber-loop-control bridge-group 1 spanning-disabled bridge-group 1 block-unknown-source no bridge-group 1 source-learning no bridge-group 1 unicast-flooding ! interface Vlan1 description LAN no ip address load-interval 30 bridge-group 1 ! interface BVI1 description Connection to LAN & WLAN ip address 192.168.0.1 255.255.255.0 ip verify unicast reverse-path no ip redirects no ip unreachables no ip proxy-arp ip virtual-reassembly ip route-cache flow load-interval 30 ! Hope this helps Ziv -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Justin Shore Sent: Thursday, May 21, 2009 4:56 AM To: 'Cisco-nsp' Subject: [c-nsp] OT: 871W config I've got an off-topic plea. I'm trying to configure a simple little 871W as a CE that I need to deploy next week. The wifi on this thing is kicking my ass. 881Ws are completely different than their 871W ancestors. 881Ws have a logically separate internal AP that you basically session into. The 871W's radio is integrated into the router's config itself. I can't for the life of me get wifi sub-ints to bridge onto the SVIs that I'm using on the wired side (3x VLANs: data, voice, and guest). I found a config guide online that showed SVIs configured with nothing but the bridge-group commands, BVIs corresponding to those bridge-groups where all the L3 config now resides, and then normal Dot11Radio sub-ints with matching bridge-groups. However doing this and putting the bridge-group commands on the SVIs breaks the wired connectivity (and doesn't make wifi work anyway). Does anyone have a working config for a 871W that they wouldn't mind sharing off-list? This should be a trivially minor config and for some reason it's thoroughly stumping me. Thanks Justin _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ ************************************************************************************ This footnote confirms that this email message has been scanned by PineApp Mail-SeCure for the presence of malicious code, vandals & computer viruses. ************************************************************************************ ************************************************************************************ This footnote confirms that this email message has been scanned by PineApp Mail-SeCure for the presence of malicious code, vandals & computer viruses. ************************************************************************************ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
