Check the config-register, as Aaron suggests, but also check the SP's config-register.
#remote command switch show boot If the RP shows 0x2102 but the SP is something else, that could be the problem. To fix, go into config mode on the RP and re-enter the 0x2102 config-register, ^Z, then write mem. Cheers, Dale On Thu, Jun 11, 2009 at 3:24 AM, Childs, Aaron<[email protected]> wrote: > What's the configuration register set to? (sh boot) once you're in IOS. 0x0 > will bring you to rommon everytime, 0x2102 will boot the sup using the config > file. > > Aaron > > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of Renelson Panosky > Sent: Wednesday, June 10, 2009 12:41 PM > To: [email protected] > Subject: [c-nsp] need help with 6509-E with WS-SUP32-GE-3B > > I Have a brand new 6509-E with WS-SUP32-GE-3B booting up in rommon> mode i > was able to type the command boot so it can look for the right code to boot > up but after i configured the switch i turned off and turned it back on, it > boot up in rommon mode again and everything was lost. I know someone had > upgraded the IOS and i am sure that's what causing the problem and i know > there is command i can type to fix the problem but i can't remember it or > find it on the web can someone please help me out with this ? > > Renelson _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
