MLPPP working config below. Do the same thing on the remote router ie:create multilink interface with IP address and add DS1 interfaces to multilink group interface Multilink1 description Orinda bundle DS3 channels 11,18,12 ip address xxx.xxx.x.177 255.255.255.252 ip flow ingress ppp multilink multilink-group 1 service-policy output MLPPP-4.6 interface Serial1/0/0/11:0 description Orinda #1 Circuit ID xxxx-001PT no ip address encapsulation ppp ppp multilink multilink-group 1 ! interface Serial1/0/0/12:0 description Link to Orinda #3 CID xxx-001PT no ip address encapsulation ppp ppp multilink multilink-group 1 interface Serial1/0/0/18:0
description Orinda USD #2 Circuit ID xxx-001PT no ip address encapsulation ppp ppp multilink multilink-group 1 --- On Tue, 10/20/09, Dominic <[email protected]> wrote: From: Dominic <[email protected]> Subject: [c-nsp] Bonded T1 Circuits To: [email protected] Date: Tuesday, October 20, 2009, 8:05 AM Hi Everyone: Two questions: 1. I need to bond two T1 circuits. Does anyone have a working sample config? The POP end is a 7206VXR with NPE-G2 and the PA-MC-2T3-EC Card, and the customer end is a Cisco 1841. 2. Also need to bond as many as 4 T1s. Would that be pushing it, and what would generally be the cleanest way to do it? Dominic _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
