Correct..input only: Switch(config-if)#service-policy output 10Mbps police command is not supported for this interface Configuration failed! Warning: Assigning a policy map to the output side of an interface not supported
-- Randy ---------- Original Message ----------- From: Jon Lewis <[email protected]> To: Randy McAnally <[email protected]> Cc: cisco-nsp <[email protected]> Sent: Mon, 22 Feb 2010 14:39:05 -0500 (EST) Subject: Re: [c-nsp] what is it with 3550s? > On Mon, 22 Feb 2010, Randy McAnally wrote: > > > interface GigabitEthernet1/0/8 > > switchport access vlan 24 > > spanning-tree portfast > > service-policy input 10Mbps > > ! > > Right...but on the 3750, can you > > interface GigabitEthernet1/0/8 > switchport access vlan 24 > spanning-tree portfast > service-policy input 10Mbps-in > service-policy output 10Mbps-out > > On the 3550, you can do this. We use different policies (for in/out) > because the supported class-map matching for ingress/egress are different. > > My understanding is, on the 3560 (and likely the 3750, as it's about > the same as a 3560 with stacking) that output service-policy is not configurable. > > ---------------------------------------------------------------------- > Jon Lewis | I route > Senior Network Engineer | therefore you are > Atlantic Net | > _________ http://www.lewis.org/~jlewis/pgp for PGP public key_________ ------- End of Original Message ------- _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
