Hi all, I'm going to be deploying some old 3550's as CPE on a Fibre-over-Ethernet network. I've never used a layer-3 switch for this job before, I've always used a router with a separate switch. I'm looking for some advice, as the setup is a bit different from what I'm used to.
What I think I have to do is this: - trunk vlan 768 through gi0/1 back to my PE router - configure an int vlan768 to contain the /30 ptp IP - configure a second vlan (eg: 5) and apply one of the client's IP addresses on it (which will act as their default gw) - configure the fa interfaces as access ports for vlan 5 - enable ip-routing - set up BGP as usual, using int vlan768 as the update-source Does this sound right? Can anyone offer any other advice regarding this setup, particularly any config techniques that I should know about for this type of deployment? Steve _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
