Thank you all for the input on router selection. Even though the power supplies are on the rear of the 7200 it seems it is on the allowed equipment listing for the carrier we are going to be co-locating with.
It turns out that the OC-12 requirement was changed to OC-3. This is making us lean towards 7200's (we have 7200 spares already from left over dial shelves). Can anyone tell me what is the performance (Mb/s, PPS) I would expect to get out of a NPE-G1 and also can it handle full internet routing table (with max memory)? Also what is the most stable/trusted ver of IOS for 7200 with NPE-G1 (BGP internet router... no MPLS). Thanks again for all your input! -Rich On Tue, Mar 30, 2010 at 9:25 PM, scott owens <[email protected]> wrote: > You know that NEBs has different levels of compliance ? > http://www.nebs-faq.com/what_is_nebs_level_3.htm > > If this is for a short term ( 1 month or 6 ? ) > do you REALLY need a super duper studly box ? > Are you going to have to do the conversion from an OC circuit or can you > get > this in a gigE ? > Carriers have adopted over the last few years and optical is not always the > only choice > If you could get away with gigE you could buy a 3845 w/gig of ram for under > 5K - I have a 3845 in test lab w/2 1GB and some optical. > > 7201s can go to 2 gb ram and have a PA slot > > Are you going to be doing POS, ATM, ????. Is your rendundancy requirements > 2 holes in one box ? 2 boxes ? > Is the interface OC12 but with a lower pps requirements ? > If you could get away with a 7206 shoot me an email I may have one or two > I > could lend if they would work > <http://www.nebs-faq.com/what_is_nebs_level_3.htm> > > > Message: 4 > > Date: Tue, 30 Mar 2010 15:34:56 -0400 > > From: Rich Davies <[email protected]> > > To: [email protected] > > Subject: [c-nsp] Need input for router purchase > > Message-ID: > > <[email protected]> > > Content-Type: text/plain; charset=ISO-8859-1 > > > > Hello, > > > > I am involved with a short-term project involving the > purchase/installation > > of a Cisco router which is capable of the following: > > > > - OC-12 WAN interface > > - High throughout (PPS) > > - Redundancy > > - Full routing table > > > > I have looked at the 7600 and it is a viable option however we are also > > looking at anything that will help cut costs down (i.e., 7206 VXR with > NPE > > G1/G2 and so on). One "key" thing we need is this equipment will be > > installed with a carrier that has high demands (NEBS compliancy etc). > > What would be the best router to investigate for such needs? (ASR?) > > > > > > -Rich > > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
