Hi, I'm not sure if you have seen this beauty...
Labbing SXH7 before upgrading production machines, I configured a port
from its default state on the lab box (switchport) to "test EoMPLS here",
and after the test was done, I wanted to configure the port back.
- "default interface gi5/2", then "put switchport config back in".
... and this is what I get:
Cisco-M-LAB(config)#int g5/2
Cisco-M-LAB(config-if)#swi
GigabitEthernet5/2: Port mode modified in another CLI session, ignoring [no]
switchport cmd
Cisco-M-LAB(config-if)#^Z
Cisco-M-LAB#who
Line User Host(s) Idle Location
* 1 vty 0 gert idle 00:00:00 195.30.x.x
Interface User Mode Idle Peer Address
Cisco-M-LAB#sh run int g5/2
Building configuration...
Current configuration : 51 bytes
!
interface GigabitEthernet5/2
no ip address
end
... there's exactly *me* on this router, nobody else is logged in,
but it's still refusing to cooperate...
*sigh*
I don't think I can bear opening a TAC case for this, I think I will just
go somewhere and laugh manically for a few minutes...
gert
--
USENET is *not* the non-clickable part of WWW!
//www.muc.de/~gert/
Gert Doering - Munich, Germany [email protected]
fax: +49-89-35655025 [email protected]
pgp14PWpn1Prw.pgp
Description: PGP signature
_______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
