Could it be a software bug by any chance? Those 3ge cards are pretty old...look for CSCsc66938 on this page: http://www.cisco.com/en/US/docs/ios/12_0s/release/ntes/120SCAVS.html
<http://www.cisco.com/en/US/docs/ios/12_0s/release/ntes/120SCAVS.html>-- Stephen F. Cobb • Senior Sales Engineer CCNA/CCDA/DCNID/ATSP Telecoast Communications, LLC • Santa Barbara, CA o 877.677.1182 x272 • c 760.807.0570 • f 805.618.1610 aim/yahoo telecoaststephen On Tue, May 4, 2010 at 3:38 PM, Billy Guthrie <[email protected]> wrote: > Dominic, > > I have a link in my history, so I am sure that I have seen the issue but do > not recall the specifics. > > > http://www.cisco.com/en/US/products/hw/routers/ps359/products_tech_note09186a0080110d68.shtml#ts3 > > > Good luck. > > Billy > > > Dominic wrote: > >> Hi Everyone: >> >> I am curious: is anyone doing BGP, with Full routes, on a GSR? >> I am asking because, I have Transit circuit terminated on a 3-Port GigE >> Line Card, on a GSR 12008 runing PRP-2. Remote peer is sending FULL BGP >> routes. As soon as the BGP session comes up, however, the line card >> crashes/resets. Setting the maximum-prefix BGP parameter to a really low >> level makes no difference. The LC is configured with the maximum possible >> MEM available for that device, and this is the only BGP session on the >> entire box. >> >> >> Here is the crashing error I get: >> >> May 4 16:40:07 gsr1-BUFF 4361795: May 4 20:40:06.405: %BGP-5-ADJCHANGE: >> neighbor X.X.X.X Up >> May 4 16:40:45 gsr1-BUFF 4361798: May 4 20:40:44.795: %FIB-2-FIBDISABLE: >> Fatal error, slot 3: IPC Failure: timeout >> May 4 16:40:45 gsr1-BUFF 4361799: May 4 20:40:44.795: %RP-4-RSTSLOT: >> Resetting the card in the slot: 3,Event: CEF failure >> -------------------------------------- >> >> Here is the show diag from the Line Card: >> >> SLOT 3 (RP/LC 3 ): 3 Port Gigabit Ethernet >> MAIN: type 68, 800-6376-03 rev C0 >> Deviation: D008017 >> HW config: 0x00 SW key: 00-00-00 >> PCA: 73-4775-06 rev B0 ver 2 >> Design Release 2.0 S/N CAB0527JGN1 >> MBUS: Embedded Agent >> Test hist: 0x00 RMA#: 00-00-00 RMA hist: 0x00 >> DIAG: Test count: 0x05000006 Test results: 0x00000000 >> FRU: Linecard/Module: 3GE-GBIC-SC= >> Processor Memory: MEM-GRP/LC-256= >> Packet Memory: MEM-PKT-512-UPG= >> L3 Engine: 2 - Backbone OC48 (2.5 Gbps) >> MBUS Agent Software version 2.70 (RAM) (ROM version is 3.67) >> ROM Monitor version 19.1 >> Fabric Downloader version used 11.5 (ROM version is 11.5) >> Primary clock is CSC 1 >> Board is analyzed >> Board State is Line Card Enabled (IOS RUN ) >> Insertion time: 24w4d (00:28:12 ago) >> Processor Memory size: 268435456 bytes >> TX Packet Memory size: 268435456 bytes, Packet Memory pagesize: 16384 >> bytes >> RX Packet Memory size: 268435456 bytes, Packet Memory pagesize: 16384 >> bytes >> 1 crash since restart >> ------------------------- >> >> And For the Processor diag: >> >> show diags 0 >> >> SLOT 0 (RP/LC 0 ): Performance Route Processor >> MAIN: type 96, 800-23469-02 rev A0 >> Deviation: D074404, D074394, D073524 >> HW config: 0x10 SW key: 00-00-00 >> PCA: 73-8812-05 rev A0 ver 5 >> Design Release 0.0 S/N SAD082805A5 >> MBUS: MBUS Agent (1) 73-8048-06 rev A0 dev 0 >> HW version 0.1 S/N CAT08180BD7 >> Test hist: 0x00 RMA#: 00-00-00 RMA hist: 0x00 >> DIAG: Test count: 0x00000000 Test results: 0x00000000 >> FRU: Linecard/Module: PRP-2= >> Route Memory: MEM-PRP/LC-3584= >> MBUS Agent Software version 2.70 (RAM) (ROM version is 3.68) >> ROM Monitor version 1.23(0.36) >> Primary clock is CSC 1 >> Board State is IOS Running ACTIVE (ACTV RP ) >> Insertion time: 00:00:07 (24w4d ago) >> DRAM size: 3758096384 bytes >> DRAM DIMM Slot 1: 2048M found, Slot 2: 2048M found >> >> ------------------- >> >> >> Here is the BGP Config: >> >> router bgp xxxx >> no synchronization >> bgp router-id x.x.x.x >> no bgp fast-external-fallover >> bgp log-neighbor-changes >> bgp dampening >> network x.x.x.x mask 255.255.254.0 >> network x.x.x.x mask 255.255.252.0 >> redistribute static >> neighbor x.x.x.x remote-as x.x.x.x >> neighbor x.x.x.x description Telco1 >> neighbor x.x.x.x password 7 xxxxx >> neighbor x.x.x.x ebgp-multihop 5 >> neighbor x.x.x.x version 4 >> neighbor x.x.x.x route-map BGP-OUTGOING out >> neighbor x.x.x.x maximum-prefix 400000 warning-only >> no auto-summary >> >> >> Any help would be appreciated. >> Thanks. >> >> >> Dominic >> _______________________________________________ >> cisco-nsp mailing list [email protected] >> https://puck.nether.net/mailman/listinfo/cisco-nsp >> archive at http://puck.nether.net/pipermail/cisco-nsp/ >> >> >> > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
