Hello Dominic: It looks like you only have 256 Mb of Packet Ram. You should probably upgrade to 512 MB. I run multiple full peers on 3 port GE cards with no trouble, but they are all set to 512/512.
Regards, Mike On 5/4/10 2:03 PM, "Dominic" <[email protected]> wrote: > Hi Everyone: > > I am curious: is anyone doing BGP, with Full routes, on a GSR? > > I am asking because, I have Transit circuit terminated on a 3-Port GigE Line > Card, on a GSR 12008 runing PRP-2. Remote peer is sending FULL BGP routes. As > soon as the BGP session comes up, however, the line card crashes/resets. > Setting the maximum-prefix BGP parameter to a really low level makes no > difference. The LC is configured with the maximum possible MEM available for > that device, and this is the only BGP session on the entire box. > > > Here is the crashing error I get: > > May 4 16:40:07 gsr1-BUFF 4361795: May 4 20:40:06.405: %BGP-5-ADJCHANGE: > neighbor X.X.X.X Up > May 4 16:40:45 gsr1-BUFF 4361798: May 4 20:40:44.795: %FIB-2-FIBDISABLE: > Fatal error, slot 3: IPC Failure: timeout > May 4 16:40:45 gsr1-BUFF 4361799: May 4 20:40:44.795: %RP-4-RSTSLOT: > Resetting the card in the slot: 3,Event: CEF failure > -------------------------------------- > > Here is the show diag from the Line Card: > > SLOT 3 (RP/LC 3 ): 3 Port Gigabit Ethernet > MAIN: type 68, 800-6376-03 rev C0 > Deviation: D008017 > HW config: 0x00 SW key: 00-00-00 > PCA: 73-4775-06 rev B0 ver 2 > Design Release 2.0 S/N CAB0527JGN1 > MBUS: Embedded Agent > Test hist: 0x00 RMA#: 00-00-00 RMA hist: 0x00 > DIAG: Test count: 0x05000006 Test results: 0x00000000 > FRU: Linecard/Module: 3GE-GBIC-SC= > Processor Memory: MEM-GRP/LC-256= > Packet Memory: MEM-PKT-512-UPG= > L3 Engine: 2 - Backbone OC48 (2.5 Gbps) > MBUS Agent Software version 2.70 (RAM) (ROM version is 3.67) > ROM Monitor version 19.1 > Fabric Downloader version used 11.5 (ROM version is 11.5) > Primary clock is CSC 1 > Board is analyzed > Board State is Line Card Enabled (IOS RUN ) > Insertion time: 24w4d (00:28:12 ago) > Processor Memory size: 268435456 bytes > TX Packet Memory size: 268435456 bytes, Packet Memory pagesize: 16384 bytes > RX Packet Memory size: 268435456 bytes, Packet Memory pagesize: 16384 bytes > 1 crash since restart > ------------------------- > > And For the Processor diag: > > show diags 0 > > SLOT 0 (RP/LC 0 ): Performance Route Processor > MAIN: type 96, 800-23469-02 rev A0 > Deviation: D074404, D074394, D073524 > HW config: 0x10 SW key: 00-00-00 > PCA: 73-8812-05 rev A0 ver 5 > Design Release 0.0 S/N SAD082805A5 > MBUS: MBUS Agent (1) 73-8048-06 rev A0 dev 0 > HW version 0.1 S/N CAT08180BD7 > Test hist: 0x00 RMA#: 00-00-00 RMA hist: 0x00 > DIAG: Test count: 0x00000000 Test results: 0x00000000 > FRU: Linecard/Module: PRP-2= > Route Memory: MEM-PRP/LC-3584= > MBUS Agent Software version 2.70 (RAM) (ROM version is 3.68) > ROM Monitor version 1.23(0.36) > Primary clock is CSC 1 > Board State is IOS Running ACTIVE (ACTV RP ) > Insertion time: 00:00:07 (24w4d ago) > DRAM size: 3758096384 bytes > DRAM DIMM Slot 1: 2048M found, Slot 2: 2048M found > > ------------------- > > > Here is the BGP Config: > > router bgp xxxx > no synchronization > bgp router-id x.x.x.x > no bgp fast-external-fallover > bgp log-neighbor-changes > bgp dampening > network x.x.x.x mask 255.255.254.0 > network x.x.x.x mask 255.255.252.0 > redistribute static > neighbor x.x.x.x remote-as x.x.x.x > neighbor x.x.x.x description Telco1 > neighbor x.x.x.x password 7 xxxxx > neighbor x.x.x.x ebgp-multihop 5 > neighbor x.x.x.x version 4 > neighbor x.x.x.x route-map BGP-OUTGOING out > neighbor x.x.x.x maximum-prefix 400000 warning-only > no auto-summary > > > Any help would be appreciated. > Thanks. > > > Dominic > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
