Hi Arie, list,
A quick check on the KB shows that 12.4(15)T should have EoMPLS
support... Hope my search was not too quick.
Alas... tried 12.4(15)T11 (,jk9o3s) but:
* "xconnect" only supports L2TPv3, not MPLS encap
* "mpls l2transport" commands not available
* "show mpls l2transport capability int <if>" only shows "core"
functionality, edge is not supported:
===
Transport type Eth VLAN
Core functionality:
MPLS label disposition supported
Control word processing supported
Sequence number processing not supported
VCCV CC Type CW [1] processing supported
Edge functionality:
Not supported
Transport type Ethernet
Core functionality:
MPLS label disposition supported
Control word processing supported
Sequence number processing not supported
VCCV CC Type CW [1] processing supported
Edge functionality:
Not supported
===
That's about the same output as on my ancient c7200 with NPE-200 and
100FX interface. I guess the "edge" functionality is what's missing
every time.
I managed to find a 12.2S image, but it is 12.2(14)S5 and AToM support
was first included in 12.2(14)S8 according to the docs I found. So I
guess I'll have to give up here and see if I can get some affordable
hardware for my AToM labbing. What I've found so far is that a 7200VXR
with gig interfaces might do it...
(open to suggestions and I'd still be eternally grateful to anyone who
can throw a c7400 12.2(14)S8 or higher image in my direction).
- Jeroen
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
