Hi, I have upgraded CRS1 to 4.0.1 from 3.6.2. Upgrade worked fine and it is running 4.0.1. But the issue is I am not able to downgrade it back to 3.6.2
If I am trying to run any install command I see similar output - RP/0/RP0/CPU0:crs1.BLB(admin)#install commit Fri Feb 25 03:45:10.181 UTC Install operation 402 '(admin) install commit' started by user 'colt123' via CLI at 03:45:10 UTC Fri Feb 25 2011. Error: Cannot proceed with the operation because the upgrade package is Error: active. Error: Error: The package should only be used when upgrading from software RP/0/RP0/CPU0:Feb 25 03:45:11.503 : instdir[216]: %INSTALL-INSTMGR-3-INSTALL_OPERATION_USER_ERROR : User error occurred during install operation 402. See 'show install log 402 detail' for more inError: versions prior to 4.0.0. Once the upgrade is complete, it should be formation. Error: immediately deactivated and removed. No further install operations Error: will be allowed until this is completed. Error: Error: Deactivate the package from the entire router by executing the Error: 'install deactivate ' command in admin mode. Error: Remove the package from the entire router by executing the 'install Error: remove ' command in admin mode. Error: No further install operations will be allowed until this is Error: completed. Install operation 402 failed at 03:45:11 UTC Fri Feb 25 2011. I have also checked on the active and inactive files and could not locate upgrade package on active disk (boot disk). Does anyone has faced similar issue? Regards, Vikas _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
