Also I can see this log which clearly says no upgrade package is available but then why it asks to uninstall the upgrade package..
Fri Feb 25 02:26:03.572 UTC Install operation 396 '(admin) install remove disk1:hfr-upgrade-p.pie-4.0.1 synchronous' started by user 'colt123' via CLI at 02:26:04 UTC Fri Feb 25 2011. P/0/RP0/CPU0:Feb 25 02:26:04.876 : instdir[216]: %INSTALL-INSTMGR-3-INSTALL_OPERATION_USER_ERROR : User error occurred during install operation 396. See 'show install log 396 detail' for more inKformation. Warning: The following specified package does not use the boot device, and so Warning: will not be removed: Warning: disk1:hfr-upgrade-p.pie-4.0.1 Error: There are no valid packages on the boot device to be removed. Regards, VIkas On Fri, Feb 25, 2011 at 4:33 PM, Vikas Sharma <[email protected]>wrote: > Hi, > > I have upgraded CRS1 to 4.0.1 from 3.6.2. Upgrade worked fine and it is > running 4.0.1. But the issue is I am not able to downgrade it back to 3.6.2 > > If I am trying to run any install command I see similar output - > > RP/0/RP0/CPU0:crs1.BLB(admin)#install commit > Fri Feb 25 03:45:10.181 UTC > Install operation 402 '(admin) install commit' started by user 'colt123' > via > CLI at 03:45:10 UTC Fri Feb 25 2011. > Error: Cannot proceed with the operation because the upgrade package is > Error: active. > Error: > Error: The package should only be used when upgrading from software > RP/0/RP0/CPU0:Feb 25 03:45:11.503 : instdir[216]: > %INSTALL-INSTMGR-3-INSTALL_OPERATION_USER_ERROR : User error occurred during > install operation 402. See 'show install log 402 detail' for more > inError: versions prior to 4.0.0. Once the upgrade is complete, it should > be > formation. > Error: immediately deactivated and removed. No further install > operations > Error: will be allowed until this is completed. > Error: > Error: Deactivate the package from the entire router by executing the > Error: 'install deactivate ' command in admin mode. > Error: Remove the package from the entire router by executing the > 'install > Error: remove ' command in admin mode. > Error: No further install operations will be allowed until this is > Error: completed. > Install operation 402 failed at 03:45:11 UTC Fri Feb 25 2011. > I have also checked on the active and inactive files and could not locate > upgrade package on active disk (boot disk). Does anyone has faced similar > issue? > > Regards, > Vikas > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
