int lo0 ip ospf network point-to-point That'll advertise lo0 address with configured mask instead of /32.
On Fri, Jul 15, 2011 at 11:27 AM, Alexandre Durand <[email protected]> wrote: > Hi Andrew, > > No negociate is not available ont he interface. and i forced speed and > duplex but with no success to turn this port up. > > regards > > On 15/07/11 11:05, Andrew Miehs wrote: >> >> On Fri, Jul 15, 2011 at 9:07 AM, Alexandre Durand >> <[email protected] <mailto:[email protected]>> >> wrote: >> >> I have been trying to force a giga port to come up without any >> physical device connected on this port wuith a c6500. I thought >> the trick was to set no keepalive on the interface but the port is >> not coming up and stays down. >> I also disabled auto negogation and turned the port in to speed >> 1000 and duplex full but wih no sucess either. >> >> Is there someone who has ever experienced the trick? >> >> On an ethernet you could try enabling "no negotiate" on the interface, and >> force speed and duplex. >> Regards >> >> Andrew > > > -- > Alexandre DURAND > TAS FRANCE > WTC 1-K, 1300 route des Crêtes > 06560 Valbonne Sophia Antipolis > Phone : +33 (0)4 92 94 56 93 > Fax : +33 (0)4 92 94 33 99 > Web: http://www.tasfrance.com > Email : [email protected] > peering: http://as8554.peeringdb.com > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
