Hello Jay, you can a apply a route-map that would do PBR on the traffic generated by the router like this:
route-map LocalPolicy permit 10 match ip address PingISP_A set interface Serial0/0/0 ip local policy route-map LocalPolicy Seems like your scenario perfectly matches the one described by Ivan on http://www.nil.com/ipcorner/RedundantMultiHoming/ -pavel On Thu, Jul 28, 2011 at 8:29 AM, Jay Nakamura <[email protected]> wrote: > Let's say a router is setup with connection to ISP 1 and ISP 2, which > are both non-BGP connection and traffic coming in from ISP 1 can't go > out ISP 2 and visa versa. Default route is set on ISP 1, with IP > SLA, failover to ISP 2. > > I can configure NAT so it will NAT on the correct IP for each egress > connection. This is not the issue. > > Is there a way, for example, a ping to the router coming into ISP2 can > be sent back out ISP2 when ISP2 is not the default route? Normal PBR > applied to ingress traffic on the interface so I wasn't sure what > could be done with traffic originating on the router. > > Thanks! > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
