Not exactly your scenario, but an ASR1006 w/RP2 can get stable in ~40 secs with two route-reflectors carrying full routes:
Almost...notice the InQ Neighbor V AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/PfxRcd x.x.x.x 4 XXXXX 98486 5 406609 154 0 00:00:35 354637 x.x.x.y 4 XXXXX 92612 5 406609 124 0 00:00:35 332391 InQ empty: Neighbor V AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/PfxRcd x.x.x.x 4 XXXXX 100592 5 417339 0 0 00:00:36 361088 x.x.x.y 4 XXXXX 100594 5 417339 0 0 00:00:37 361088 --chip On Mon, Aug 15, 2011 at 8:02 PM, Brent Roberts <[email protected]> wrote: > Can anyone provide real world BGP Table convergence times on 3 full Peers on > an ASR 1006 RP2 for IPV4. Strictly in the IP V4 world scheme. Timing > reference being sought is for the equivalent of "CLEAR IP BGP ALL" Command. > Service engine would be a ASR1000-ESP10. > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > -- Just my $.02, your mileage may vary, batteries not included, etc.... _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
