In what configuration does an NPE G1 load tables in under a minute?
I haven't seen one load a full table in anywhere near sub 1 min.
G2 yes, G1 really?
-----Original Message-----
From: Saku Ytti
Sent: Wednesday, August 17, 2011 7:54 AM
To: cisco-nsp@puck.nether.net
Subject: Re: [c-nsp] BGP router upgrade
On (2011-08-17 02:07 +0200), Lars Eidsheim wrote:
- Load times of the full BGP table will be higher than the NPE-G1/2 - do
anyone know the respective load times? Do you expect to see 1 minute or 10
minutes?
SUP720-3BXL can load BGP table in under 1min, but NPE-G1 can do lot better.
But initial convergence is hardly very interesting metric.
- Do we benefit to use DFC at the linecards when traffic rate is low
(guessing 5 to 10 mpps)? Will DFC still be recommended for my setup?
No, I wouldn't run DFC until I need them. Decentralization carries some
complexity and may include some surprises like inability to police
accurately.
- Will the 7600/RSP720 be a better choice, still using 67xx linecards?
RSP720 has MSFC4 so control-plane is snappier.
--
++ytti
_______________________________________________
cisco-nsp mailing list cisco-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list cisco-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
