On Wednesday, December 28, 2011 05:51:09 PM Vitkovsky, Adam wrote: > Show run should display the configuration for the card > that was removed and all it's references in the config > It will jut list the interfaces as "interface > preconfigure gig0/2/3/4" -same as when you pre-configure > interfaces for a line-card that is not yet inserted into > the box or you'd like to adjust the broken card's config > prior to inserting the new card
We've used that before - what I know is that 'preconfigure' will only display configurations of a previously removed line card if the interfaces were initially configured with the 'preconfigure' command. We haven't tested this by taking out a line card, but I recall that this was one of the restrictions. Cheers, Mark.
signature.asc
Description: This is a digitally signed message part.
_______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
