Dear Cisco gurus,
I have the following simple config for a frame-relay T1 on Megapath's
network:
interface FastEthernet0/0
ip address x.x.x.x x.x.x.x !!!!!!!!!!!!(publicly addressable /29)
duplex auto
speed auto
!
interface Serial0/0
no ip address
encapsulation frame-relay IETF
no fair-queue
frame-relay interface-dlci 16 ppp Virtual-Template1 !!!!!!!!!(I've seen
examples where this line is entered on a sub-interface - not sure if this
matters)
frame-relay lmi-type ansi
!
interface Virtual-Template1
ip address negotiated
ppp chap hostname username@bz8
ppp chap password 0 password
ppp ipcp dns request
ppp ipcp route default
ppp ipcp address accept
!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
The issue I have is, there's no connectivity from the router itself.
Anything behind the router - using the LAN IP block - works fine. For
example, within the Cisco CLI, if I issue the ping command by itself, I get
no reply. If I issue the ping command & specify that the source address is
the IP on the FastE interface, then I get replies.
Is something fundamentally wrong with my config? Or is this simply the
result
of Megapath provisioning? If so, is there a simple way to workaround the
issue? Such as making ALL traffic from the router appear to originate from
the IP on the FastE interface.
Thanks in advance for your help/replies.
Bill
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
