Bill, Add:
interface serial0/0 ip unnumbered ethernet 0 And see if it helps. Javier Henderson [email protected] On Feb 23, 2012, at 2:06 PM, <[email protected]> <[email protected]> wrote: > Dear Cisco gurus, > > I have the following simple config for a frame-relay T1 on Megapath's > network: > > interface FastEthernet0/0 > ip address x.x.x.x x.x.x.x !!!!!!!!!!!!(publicly addressable /29) > duplex auto > speed auto > ! > interface Serial0/0 > no ip address > encapsulation frame-relay IETF > no fair-queue > frame-relay interface-dlci 16 ppp Virtual-Template1 !!!!!!!!!(I've seen > examples where this line is entered on a sub-interface - not sure if this > matters) > frame-relay lmi-type ansi > ! > interface Virtual-Template1 > ip address negotiated > ppp chap hostname username@bz8 > ppp chap password 0 password > ppp ipcp dns request > ppp ipcp route default > ppp ipcp address accept > ! > !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! > The issue I have is, there's no connectivity from the router itself. > Anything behind the router - using the LAN IP block - works fine. For > example, within the Cisco CLI, if I issue the ping command by itself, I get > no reply. If I issue the ping command & specify that the source address is > the IP on the FastE interface, then I get replies. > > Is something fundamentally wrong with my config? Or is this simply the result > of Megapath provisioning? If so, is there a simple way to workaround the > issue? Such as making ALL traffic from the router appear to originate from > the IP on the FastE interface. > > Thanks in advance for your help/replies. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
