Odds are you have non routed address on the wan interface.
Bill wrote:
Dear Cisco gurus, I have the following simple config for a frame-relay T1 on Megapath's network: interface FastEthernet0/0 ip address x.x.x.x x.x.x.x !!!!!!!!!!!!(publicly addressable /29) duplex auto speed auto ! interface Serial0/0 no ip address encapsulation frame-relay IETF no fair-queue frame-relay interface-dlci 16 ppp Virtual-Template1 !!!!!!!!!(I've seen examples where this line is entered on a sub-interface - not sure if this matters) frame-relay lmi-type ansi ! interface Virtual-Template1 ip address negotiated ppp chap hostname username@bz8 ppp chap password 0 password ppp ipcp dns request ppp ipcp route default ppp ipcp address accept ! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! The issue I have is, there's no connectivity from the router itself. Anything behind the router - using the LAN IP block - works fine. For example, within the Cisco CLI, if I issue the ping command by itself, I get no reply. If I issue the ping command & specify that the source address is the IP on the FastE interface, then I get replies. This seems to me like an issue with the way Megapath provisions these circuits but I'm trying to see if there's a simple way to workaround the issue. Such as making ALL traffic from the router appear to originate from the IP on the FastE interface. Thanks in advance for your help/replies. Bill _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
