In most cases, a topology like this will have the ONS's synced to GPS time, or some accurate clock (or line clocking if your ONS connects to another provider, but GPS is typically preferred) and then I would DEFINITELY use line clocking on the PA-MC-T3, unless you have the capability through a clock card to connect the 7204 to the same timing source as the ONS uses (ie: GPS derived clock) Whenever possible, keep all devices in sync with a common clock
----- Original Message ----- From: "Natambu Obleton" <[email protected]> To: [email protected] Sent: Tuesday, June 5, 2012 2:17:54 PM Subject: [c-nsp] CT3 Timing issue Hello, I have a customer with a 2xT1 MPPP link to my 7204. The T1 come in to the 7204 on different PA-MC-T3 cards. The PA-MC-T3 cards plug into my ONS 15454 SONET network. When I have timing set on the CPE to one of the T1s the other T1 gets slips and vice versa. Both of the PA-MC-T3 are set for internal timing. Shouldn't their timing be the same or should I have these setup for line timing? Thanks. -- Natambu Obleton, CISSP CCNA Senior Network Engineer FastTrack Communications, Inc. 970.828.1009 _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
