Thanks Thomas. That's definitely an option - it was my 2nd one. The plain old subinterfaces, like on a router, don't work on this platform, apparently.
Much appreciated, Eric ________________________________ From: "[email protected]" <[email protected]> To: Eric A Louie <[email protected]>; Cisco NSP <[email protected]> Sent: Fri, October 26, 2012 10:53:09 AM Subject: Re: [c-nsp] ME3600x sub-interfaces Hi Eric, this is a switch. You have to configure a SVI Interface. conf t vlan 55 int vlan 55 ip add X.X.x.X if you want to use more vlans on a port you have to use switchport mode trunk and you should remobe the comannd switchport access vlan 55. Regards Thomas > Are sub-interfaces supported on the ME3600x? Or is there some special > formula > that I need to enable them? > > Cisco IOS Software, ME360x Software (ME360x-UNIVERSALK9-M), Version 15.2(4)S, > RELEASE SOFTWARE (fc1) > License Level: AdvancedMetroIPAccess > License Type: Permanent > > interface GigabitEthernet0/1 > no switchport > ip address 192.168.111.2 255.255.255.0 > ! > interface GigabitEthernet0/2 > description test interface > switchport access vlan 55 > switchport mode trunk > > me3600-2(config)#int g0/1.1 > ^ > % Invalid input detected at '^' marker. > > me3600-2(config)#int g0/2.1 > ^ > % Invalid input detected at '^' marker. > > > > > Much appreciated, Eric > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
