sub interface is not supported but you can use SVI to achieve the same. -Waris
On Oct 26, 2012, at 10:41 AM, "Eric A Louie" <[email protected]> wrote: > Are sub-interfaces supported on the ME3600x? Or is there some special > formula > that I need to enable them? > > Cisco IOS Software, ME360x Software (ME360x-UNIVERSALK9-M), Version 15.2(4)S, > RELEASE SOFTWARE (fc1) > License Level: AdvancedMetroIPAccess > License Type: Permanent > > interface GigabitEthernet0/1 > no switchport > ip address 192.168.111.2 255.255.255.0 > ! > interface GigabitEthernet0/2 > description test interface > switchport access vlan 55 > switchport mode trunk > > me3600-2(config)#int g0/1.1 > ^ > % Invalid input detected at '^' marker. > > me3600-2(config)#int g0/2.1 > ^ > % Invalid input detected at '^' marker. > > > > > Much appreciated, Eric > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
