Hi,
we a have a pair of ASR1001 with 4GB ram and want to max them out with 8
or 16 GB of ram. We are planning on getting one of these part numbers
from a third party supplier:
Cisco ASR1001 8GB RAM M-ASR1K-1001-8GB=
Cisco ASR1001 16GB RAM M-ASR1K-1001-16GB=
Is there any command we could use to check if we have an RP1, RP2
whatever and somehow validate above choices ?
All I can dig up is following:
# show version
cisco ASR1001 (1RU) processor with 1163580K/6147K bytes of memory.
Processor board ID xxxxxxxxxx
9 Gigabit Ethernet interfaces
32768K bytes of non-volatile configuration memory.
4194304K bytes of physical memory.
7782399K bytes of eUSB flash at bootflash:.
# show platform diag
Chassis type: ASR1001
...
Slot: R0, ASR1001
Running state : ok, active
Internal state : online
Internal operational state : ok
Physical insert detect time : 00:00:43 (1w1d ago)
Software declared up time : 00:00:43 (1w1d ago)
CPLD version : 10042219
Firmware version : 15.0(1r)S
Slot: F0, ASR1001
Running state : ok, active
Internal state : online
Internal operational state : ok
Physical insert detect time : 00:00:43 (1w1d ago)
Software declared up time : 00:01:31 (1w1d ago)
Hardware ready signal time : 00:01:20 (1w1d ago)
Packet ready signal time : 00:01:37 (1w1d ago)
CPLD version : 10042219
Firmware version : 15.0(1r)S
# show inventory
NAME: "module R0", DESCR: "Cisco ASR1001 Route Processor"
PID: ASR1001 , VID: V02, SN: xxxxxxxxxxx
Greetings
Christian
--
Christian Kratzer CK Software GmbH
Email: [email protected] Wildberger Weg 24/2
Phone: +49 7032 893 997 - 0 D-71126 Gaeufelden
Fax: +49 7032 893 997 - 9 HRB 245288, Amtsgericht Stuttgart
Web: http://www.cksoft.de/ Geschaeftsfuehrer: Christian Kratzer
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
