Sent from my iPad
> On Nov 30, 2013, at 3:19 PM, CiscoNSP List <[email protected]> wrote: > > > Looks very similar to this RFP - > http://www.gju.edu.jo/admin/u1files/GJU%20RFP.pdf > > >> Date: Sat, 30 Nov 2013 19:45:57 +0300 >> From: [email protected] >> To: [email protected] >> Subject: [c-nsp] Data Center Core Switches >> >> Dear Experts, >> >> I am in the process to acquire and implement network infrastructure >> solution by upgrading the Data Center Core Switches with a very high >> forwarding rate at least 500 Mpps and above, by using the following >> (TECHNICAL SPECIFICATION) >> >> >> 1. Modular Switch with Minimum 8 slots >> >> 2. Minimum switching capacity per slot 200Gbps >> >> 3. Switching capacity for chassis minimum 5Tbps >> >> 4. All major components including but not limited to control plane and >> power supply should be redundant where failure in one component will not >> cause any >> failure. >> >> 5. The switch must support virtualization where 2 switches can act as one >> switch eliminating need for spanning tree. >> >> 6. Energy saving (power consumption to be provided) >> >> 7. Supports for the following: >> a. VRRP >> b. NSR: Non-Stop Routing and Non-Stop Forwarding. >> c. Stateful or Graceful Switchover. Or equivalent. >> d. BFD bidirectional Forwarding Detection >> e. Hot Swappable modules. >> >> 8. The vendor should provide all licenses to support IPv4 and IPv6 full >> features. >> >> 9. Non-blocking, 1 and 10GE design >> >> 10. Support at least 500 Mpps >> >> 11. 10GE wire speed to provide adequate support for future collaboration >> applications (video, voice and high bandwidth apps) >> >> 12. Future support of 40 and 100 GE >> >> 13. The Switch should support, but not be limited to the following Layer3 >> Protocols: >> a. Static IP routing >> b. Routing Information Protocol (RIP) and RIP2 >> c. Open Shortest Path First (OSPF) >> d. BGP >> >> 14. The switch must support IP multicast protocols >> a. IGMP v1, v2, and v3 >> b. IGMP Snooping >> c. PIM-SM, PIM DM, PIM-SSM >> >> 15. The switch should support the following features at a minimum: >> a. Spanning Tree 802.1D, 802.1s, 802.1w >> b. 802.1X single and multi-supplicant: VLAN and ACL assignment >> c. DHCP Snooping, IP source guard >> d. LLDP, LLDP-MED >> e. 802.3ad >> f. Must support Multiprotocol Label Switching (MPLS) in hardware to enable >> VPN services within the campus. >> g. SNMP Support v1,2,3 >> >> The above spec could apply to juniper, cisco, hp, xtreme ...etc, any >> recommendation should I add/adjust to my TECHNICAL SPECIFICATION >> >> -mad >> _______________________________________________ >> cisco-nsp mailing list [email protected] >> https://puck.nether.net/mailman/listinfo/cisco-nsp >> archive at http://puck.nether.net/pipermail/cisco-nsp/ > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
