Hi,
I have an issue with ME3600 running 15.3(1)S. I have a BDI used for CPE management. cisco ME-3600X-24FS-M Cisco IOS Software, ME360x Software (ME360x-UNIVERSALK9-M), Version 15.3(1)S, RELEASE SOFTWARE (fc1) This is the BDI and VRF configuration: interface Vlan1620 ip vrf forwarding 65000:1620 ip address 10.232.28.1 255.255.252.0 no ip redirects ip vrf 65000:1620 rd 65000:1620 route-target export 65000:1620 route-target import 65000:1620 address-family ipv4 vrf 65000:1620 redistribute connected The MPLS part is working fine, no issues there. There is also a DHCP pool handing out IPs to the CPEs. ip dhcp pool 65000:1620 vrf 65000:1620 network 10.232.28.0 255.255.252.0 domain-name xyz default-router 10.232.28.1 option 66 ascii 10.232.28.1 dns-server 8.8.8.8 lease 0 0 30 This also works fine and I have verified that CPE has both IP and GW. Then for the service instance configuration: interface GigabitEthernet0/5 switchport trunk allowed vlan none switchport mode trunk service instance 1620 ethernet encapsulation dot1q 1620 rewrite ingress tag pop 1 symmetric bridge-domain 1620 interface GigabitEthernet0/11 switchport trunk allowed vlan none switchport mode trunk service instance 1620 ethernet encapsulation dot1q 1620 rewrite ingress tag pop 1 symmetric bridge-domain 1620 Traffic to CPEs behind Gi0/11 works: sh ip arp vrf 65000:1620 vlan 1620 | i 29.26 Internet 10.232.29.26 0 0022.07f3.3450 ARPA Vlan1620 show mac-address-table address 0022.07f3.3450 Mac Address Table ------------------------------------------- Vlan Mac Address Type Ports ---- ----------- -------- ----- 1620 0022.07f3.3450 DYNAMIC Gi0/11+Efp1620 Total Mac Addresses for this criterion: 1 Pinging 10.232.29.26 with 32 bytes of data: Reply from 10.232.29.26: bytes=32 time=33ms TTL=61 Reply from 10.232.29.26: bytes=32 time=32ms TTL=61 Reply from 10.232.29.26: bytes=32 time=34ms TTL=61 Reply from 10.232.29.26: bytes=32 time=32ms TTL=61 Traffic to CPEs behind Gi0/5 does not work. sh ip arp vrf 65000:1620 vlan 1620 | i 28.190 Internet 10.232.28.190 2 0022.07f2.76a6 ARPA Vlan1620 show mac-address-table address 0022.07f2.76a6 Mac Address Table ------------------------------------------- Vlan Mac Address Type Ports ---- ----------- -------- ----- 1620 0022.07f2.76a6 DYNAMIC Gi0/5+Efp1620 Total Mac Addresses for this criterion: 1 Pinging 10.232.28.190 with 32 bytes of data: Request timed out. Request timed out. Request timed out. Request timed out. This is also confirmed by looking at counters. There seems to be no egress traffic on Gi0/5. Service Instance 1620, Interface GigabitEthernet0/11 Pkts In Bytes In Pkts Out Bytes Out 31717 2955368 4569808 1709207624 Service Instance 1620, Interface GigabitEthernet0/5 Pkts In Bytes In Pkts Out Bytes Out 4850878 367975447 0 0 It does work to ping locally from the 3600 though: ping vrf 65000:1620 10.232.28.190 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 10.232.28.190, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/4 ms I'm not sure how to troubleshoot it further. I've also tried setting up ERSPAN sessions for RX traffic on Gi0/5 but I don't get anything in unless I ping 28.1 which is the IP of the interface on the 3600. Any clues? Regards, Daniel Dib CCIE #37149 _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
