It no just that 11 x 10 > 100 ? Perhaps you could show us the conf?
//Mattias On Mon, May 12, 2014 at 3:10 PM, James Bensley <[email protected]> wrote: > Hi All, > > Has anyone encountered this issue on the ME3600/ME3800s; > > Cisco 2960 - Layer 2 device terminating Layer 2 connections > | > | Layer 2 Trunk on 100Mbps port > | > Cisco ME3800 - Various layer 2 connections trunked up in VLANs for > termination on ME3800 > > We are trying to apply some policers on the ME3800 for multiple 10Mbps > circuits being delivered on the 2960 because some of them are on > faster bearers. The problem is that when you try to apply a policy on > the ME3x00 series and you add in an 11th policer for 10Mbps it throws > up an error saying the port is oversubscribed and the config isn't > allowed. You can't police 11+ VLANs for example to 10Mbps on a 100Mbps > port. > > These devices are meant to go near/on the access layer where > oversubscription lives :) > > Has anyone encountered this and has anyone overcome it? > > We have a TAC case open, they are almost definately going to say > "that's what is supposed to happen". > > Cheers, > James. > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > -- *Med Vänliga Hälsningar / Best Regards* *Mattias Gyllenvarg* _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
