On 8/6/2014 7:18 PM, Rod James Bio wrote:
BUT "remote command switch show mls cef max", I see:
FIB TCAM maximum routes :
=======================
Current :-
-------
IPv4 + MPLS - 512k (default)
IPv6 + IP Multicast - 256k (default)
Could this mean that the two sups are not sync? Here is the output of
show redundancy states:
Is there a way with "remote command" to run a command on the standby SP
(in other words, the supervisor, not the MSFC)? If so, do 'remote
command standby-sp show bootvar' and check the config register on the
other sup. I'm ready to start betting dollars that it's 0x0, or some
other setting that causes it to boot and hand over control to the RP
like usual BUT prevents it from reading the configuration during its
boot. This is causing the standby SP to have a mismatch with the
standby RP.
Regardless of the outcome of the above, I'd truly recommend you do this
regardless:
conf t
config-register 0x2102
end
copy run start
Then reboot at your next opportunity and tell us what you get.
Pete
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
