Looks like you are putting in some 3rd party optics. Insert this in your config: service unsupported-transceiver and it will work!
2014-08-15 10:47 GMT+02:00 Matti Saarinen <[email protected]>: > > Hello, > > I was under assumption that serivice unsupported-transceiver would make > all transceivers usable. It seems that is not the case. I tried > installing three different SFP+ optics to an SFP slot of a FourX adapter > connected to WS-X6904-40G. All these attempts resulted in the port > ending up in err-disabled state. The switch runs 15.1(2)SY2 on sup2t. > Logs show following: > > %PM_SCP-3-TRANSCEIVER_UNSUPPORTED: Unsupported transceiver in LAN port 4/13 > %PM-4-ERR_RECOVER: Attempting to recover from transceiver-incomp > err-disable state on Te4/13 > %PM-4-ERR_DISABLE: transceiver-incomp error detected on Te4/13, putting > Te4/13 in err-disable state > %PM_SCP-3-TRANSCEIVER_UNSUPPORTED: Unsupported transceiver in LAN port 4/13 > > Is this a known behaviour? Is there any workaround or do I need to buy > more Cisco like SFP+'s? The command "no errdisable detect cause > gbic-invalid" did not help. > > Cheers, > > Matti > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
