Hello, I just tried to get VRRP + IPv6 running on a Sup2T with 15.1(2)SY1. I enabled VRRPv3 and it works at least for IPv4.
But for IPv6 the status stays on status INIT: sh vrrp brief: Interface Grp A-F Pri Time Own Pre State Master addr/Group addr Vl2000 6 IPv6 100 0 N Y INIT AF-UNDEFINED no address sh vrrp vlan 2000: Vlan2000 - Group 6 - Address-Family IPv6 State is INIT State duration 49 mins 57.900 secs Virtual IP address is no address Virtual MAC address is 0000.5E00.0206 Advertisement interval is 3000 msec Preemption enabled Priority is 100 Master Router is unknown, priority is unknown Master Advertisement interval is unknown Master Down interval is unknown vlan2000 is up and other side (Juniper MX) pings fine. sh vrrp statistics shows zero-counters. Routing-Interface: interface Vlan2000 ip address x.x.x.x 255.255.255.0 no ip redirects no ip proxy-arp load-interval 30 ipv6 address xxxx:xxxx:xxxx:xxxx::3/64 ipv6 enable ipv6 nd dad attempts 0 ipv6 nd prefix default no-advertise ipv6 nd ra suppress no ipv6 redirects vrrp 6 address-family ipv6 address xxxx:xxxx:xxxx:xxxx::1/64 exit-vrrp end I would expect it to become master in case it does not work together with Juniper. I checked with a second device, same behaviour. Any hints? kind regards Rolf _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
