What we do is pretty simple actually and we have done this numerous times:
1) Take a screenshot of the device defaults 2) Install the device pack on the PUB 3) This will change other defaults, go ahead and change them back 4) Install the device pack on the sub(s) 5) Verify the defaults are the same and have not changed 6) Reboot the cluster Simple just follow these steps and you will be fine. Best of Luck Ryan. Regards Mehtab Shinwari | CCNP-V/RS, VCP-DCV Senior Support Engineer - Team Lead 7am-7pm | Fri-Sun +1-212-616-7859 office +1-212-616-7850 fax www.fidelus.com<http://www.fidelus.com/> From: cisco-voip [mailto:[email protected]] On Behalf Of Ryan Huff Sent: Saturday, January 03, 2015 3:12 PM To: [email protected] Subject: [cisco-voip] Device pack installation methodology question I need to install a device pack on a 2 node 9.1(2) CCM cluster to get support for some 88xx phones but I do not want to update the loads for anything else. The approach I am going to use is: Drop the publisher out of the CM Group, forcing all phones to the subscriber. Install the device pack on the publisher and reboot the publisher. Once the publisher is backup, set all the device defaults back to what I want them to be then add the publisher back to the CM Group. Then drop the subscriber from the CM Group forcing all the phones on the publisher and start the install process over for the subscriber. Once everything is back up add the subscriber back to the CM Group. Does that sound reasonable or is there an easier way? Thanks, Ryan
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
