If you just want to 'bridge' analog phone service this is what you need
- private line automatic ringdown (plar) means that the connection is
established as soon as one end goes off the hook. This is a point to
point config ... if you want to get fancier than this you need to create
a dial plan.
--- router one ---
voice-port 1/0/0
connection plar 194
!
!
dial-peer voice 194 voip
destination-pattern 194
codec g711ulaw
session target ipv4:x.x.x.241
!
!
dial-peer voice 1 pots
destination-pattern 167
port 1/0/0
--- router two ---
voice-port 1/0/0
connection plar 167
!
dial-peer voice 167 voip
destination-pattern 167
codec g711ulaw
session target ipv4:x.x.x.245
dial-peer voice 1 pots
destination-pattern 194
port 1/0/0
[EMAIL PROTECTED] wrote:
> hi all,
>
> here's the network layout
>
> x25 LL
> FR x25
> POTS 1 --- 1750 ------ 4500 ------ 4500 ------- 4500 ----------- 1750
> ---- POTS 2
>
> how to setup the router for voice connection from both POTS ?
> thank you very much.
>
> Best Regards,
> JC
>
> ___________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
