Hello
I keep getting the following error message from a 2501 I was recently given.
System Bootstrap, Version 4.14(9.1), SOFTWARE
Copyright (c) 1986-1994 by cisco Systems
2500 processor with 16384 Kbytes of main memory
ERR: Invalid chip id 0x80B5 (reversed = 0x1AD ) detected in System flash
% System flash query failed. Access will be RD-ONLY
--- System Configuration Dialog ---
Refer to the 'Getting Started' Guide for additional help.
Default settings are in square brackets '[]'.
Configuring interface IP parameters for netbooting:
Configuring interface Ethernet0:
Is this interface in use? [yes]: n
Configuring interface Serial0:
Is this interface in use? [yes]: n
Configuring interface Serial1:
Is this interface in use? [yes]: n
No usable interfaces
System Bootstrap, Version 4.14(9.1), SOFTWARE
Copyright (c) 1986-1994 by cisco Systems
2500 processor with 16384 Kbytes of main memory
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
1525 O'Brien Drive
Menlo Park, California 94025
3000 Bootstrap Software (IGS-RXBOOT), Version 9.14(9), RELEASE SOFTWARE
(fc1)
Patchlevel = 9.1(12.6)
Copyright (c) 1986-1994 by cisco Systems, Inc.
Compiled Wed 28-Sep-94 14:10 by chansen
ERR: Invalid chip id 0x80B5 (reversed = 0x1AD ) detected in System flash
% System flash query failed. Access will be RD-ONLY
cisco 2500 (68030) processor (revision D) with 16380K/2048K bytes of memory.
Processor board serial number 01560488
DDN X.25 software, Version 2.0, NET2 and BFE compliant.
1 Ethernet/IEEE 802.3 interface.
2 Serial network interfaces.
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Device not programmable)
--- System Configuration Dialog ---
Refer to the 'Getting Started' Guide for additional help.
Default settings are in square brackets '[]'.
Configuring interface Ethernet0:
Is this interface in use? [yes]: n
Configuring interface Serial0:
Is this interface in use? [yes]: n
Configuring interface Serial1:
Is this interface in use? [yes]: n
Press RETURN to get started!
Does anyone have any info or even better a solution
Thanks in advance
Adrian
Does anyone have any info or even better a solution
Thanks in advance
Adrian
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=71445&t=71445
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
