Tom,
That was it. The Cat1900 with the 9.00.04 Enterprise edition s/w now has
the vlan options available now. The Cat1900 with the 8.01.00 s/w does not.
The Cat1900s used in the CCNA course my coworker just took had 8.01.07
loaded so 8.01.00 may not support VLANs ... I'll just put the 9.00.04 code
on it.
Thanks,
Dave Goldsmith
-----Original Message-----
From: Tom Lisa [mailto:[EMAIL PROTECTED]]
Sent: Monday, February 05, 2001 8:10 PM
To: [EMAIL PROTECTED]
Cc: [EMAIL PROTECTED]
Subject: Re: VLANs on Catalyst 1900 Switches
Dave,
It sounds like your switches are configured for bridge groups rather than
VLANS. This
can be reset by going to the Main Menu and selecting S (System Sub-Menu).
Then select
option T (Reset to VLANS) to enable VLAN configuration. Option T changes to
Reset to
Bridge Groups when VLANS are enabled.
HTH,
Tom Lisa, Instructor, CCNA, CCAI
Community College of Southern Nevada
Cisco Regional Networking Academy
[EMAIL PROTECTED] wrote:
> I have 2 Cat1900 switches (WS-1912-A). One has the 8.01.00 Standard
Edition
> loaded and the other has the 9.00.04 Enterprise Edition loaded. On
neither
> of them are any of the VLAN commands available.
>
> The Cisco ICND book covers VLANs on Cat1900 switches and a co-worker just
> attended a GlobalKnowledge CCNA Boot Camp where they did configure VLANs
on
> Cat1900s (with version 8.xx loaded).
>
> In addition to the software version, is there a hardware issue? Do some
> Cat1900s not support VLANs?
>
> Dave Goldsmith
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
