My understanding is that in order for a PRI to take and answer an Analog
call you have to have a digital modem card installed in the router with the
PRI.
I believe that you use the following command to have the PRI take calls that
are analog: isdn incoming-voice data. I was not able to quickly find an
example of the card in use, but you can find lots of good info about the
digital modem card on the web site.
Also check out this link for more info on the digital modem card:
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis2600/net_m
od2/conntdig.htm
Jason Coleman - CCNP, CCDP
Customer Engineer
Network Management Center - Austin
(ph) 512-340-3134
(email) [EMAIL PROTECTED]
-----Original Message-----
From: Robert Fowler [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, April 24, 2001 8:57 AM
To: [EMAIL PROTECTED]
Subject: RE: DDR into a PRI [7:1701]
We have several remote sites that need to dial-in if there
frame relay
connection fails, I figured I would set them up with modems
hooked to the
aux port as a backup interface. My questions revolves around
the central
site with the PRI. I've been told my another NA that I work
with that there
is a command that you can enter that will allow you to use
the dial-in lines
directly on the router without using MICA modems. I thought
a modem had to
talk to another modem. Hope this helps. What kind of setup
did you do and
did it work successfully?
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, April 24, 2001 9:49 AM
To: [EMAIL PROTECTED]; [EMAIL PROTECTED]
Subject: RE: DDR into a PRI [7:1701]
I'm confused give me more information! I just setup a
T1-PRI with Mica
modems.
-----Original Message-----
From: Robert Fowler [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, April 24, 2001 9:32 AM
To: [EMAIL PROTECTED]
Subject: DDR into a PRI [7:1701]
Ok here is my question, Say you setup DDR with analog lines
back to a
central location with PRI, would you need to have the MICA
modems or is
there a command that will let the PRI interface card use the
lines from the
t1-PRI? I've search the CCO and I've found a lot of
information on DDR but
nothing on the specifics for coming back into a central PRI.
Lost in DDR land
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to
[EMAIL PROTECTED]
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to
[EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=1717&t=1701
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
