Hmmm, where do I start with this one? You must be trying to do it by memory and your memory doesn't seem to work to good.
Actually this would make a good Cisco test question. The question would be: What change/changes are needed to make this config work? A. Change the IP addresses to something that a router will actually take. B. Change the "network ospf 10" to "router ospf 10". C. Change the OSPF wildcard mask on router A to 0.0.255.255 from 0.0.255.255.0.0. D. Put the IP addresses in the same subnet. E. Fire the clown that tried to configure the router like this. F. All of the above. Your Friend, Angry Packet ""khramov"" wrote: > I am sorry for a stupid question. > I am trying to set up an OSPF network. So far I am doing from a router > to a router . > Here is what I have: > > Router A: > int e0/0 > ip address 192.168.30.0 255.255.255.0 > ip ospf network poin-to-point > > network ospf 10 > network 192.168.0.0 0.0.255.255.0.0 area 0 > > Router B: > int e0/0 > ip address 192.168.31.0 255.255.255.0 > ip ospf network point-to-point > > network ospf 10 > network 192.168.0.0 0.0.255.255 area 0 > > When I do sh dcp neigh I can see the router but I can not ping it. > Would you please tell me what I am doing wrong. > > Thanks in advance, > > [GroupStudy.com removed an attachment of type text/x-vcard which had a name > of khramov.vcf] [EMAIL PROTECTED] > __________________________________________________ Do You Yahoo!? Find a job, post your resume. http://careers.yahoo.com Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=26046&t=26034 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
