The only time that the "neighbor" statement will not show up in the running-config, is if you do not have a "network" statement under the "router ospf" process. I am doubting that the neighbors formed an adjacency without the neigbor or network statements showing up under the ospf config. If the adjacency was actually formed, then it must be a bug.
Another thing that I have noticed is than when trying to use the neighbor statement to set the priority, "neighbor 1.1.1.1 priority 255" the priority will change to something other than what I set it too. It took me a while to figure this one out. The problem is that I have to have matching "ip ospf priority 255" statements under the interfaces running ospf . ""John Neiberger"" wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > It was hot, too hot. Our detective had been working feverishly to > configure OSPF over NBMA without the use of ip ospf network statements. > He knew that to do this he must explicitly add neighbor statements or > adjacencies would not form. > > He logs into the hub router and types in his three neighbor statements. > All seems well. It's still too hot, but it's a dry heat. > > He now logs into one of the spoke routers and types in his neighbor > statement. He pauses momentarily and then checks the OSPF adjacencies. > Something seems to be wrong, he thinks to himself. This ought to be > working, but it isn't. Why not? He looks through the running config to > look for any errors and notices the the neighbor statement that he just > entered is missing! > > He slowly and deliberately types it in again making sure there are no > mistakes but yet it still does not show up in the running configuration. > Is this an IOS issue? Operator error? Some rift in the space-time > continuum? > > He jumps to another spoke router running a different IOS and tries the > same thing with the same result. He is frantic now, beads of sweat > pouring down his face. What if this were the real CCIE lab exam? Could > this be a fatal stumbling block? > > He finally notices that adjacencies do eventually form after clearing > the relevant interfaces. This must be because the hub router accepted > the neighbor statements. But what if it hadn't, he ponders. He thinks > forward into the future when--a day after taking the lab exam--he > receives the dreaded email that says, "We're sorry, it is apparent that > you have no clue." > > Back to the real world.... > > What was the cause of the missing neighbor statements? Have any of you > run into this before? I've never bothered to explicitly use neighbor > statements as I'm in the habit of using the ip ospf network command to > make them unnecessary. > > Any thoughts? > > Thanks, > John Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=31684&t=31656 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
