Thanks alot. I can't believe it can't run full duplex. Piece of sh*t!!!!!!!!!
""M.C. van den Bovenkamp"" wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > sam sneed wrote: > > > I'm trying to force an interface to 10 MB full duplex on a 4700 router. > > No can do, unless it's an NP-2E-FDX. If so, the command (in interface > config) would be 'full-duplex' > > See > http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis4000/2e_fd x.htm > for that. > > > The > > docemntation for 4700 is not on cisco's site. Does anyone know the command. > > It is. See the link above & one level up. Most of the rest is IOS docs. > > > Also doing a show int does not tell whether is running at half or full > > duplex and the speed. > > That's because the NP you have (NP-2E or NP-6E?) can't do anything but > 10/half, so it doesn't display it. There would be a 'hdx' or 'fdx' if it > did, something like this: > > Encapsulation ARPA, loopback not set, keepalive not set, hdx, 100BaseTX > > This is from a FE interface, obviously, but it should look similar with > a NP-2E-FDX. > > Regards, > > Marco. Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=44866&t=44844 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
