Take a look at this page: http://www.cisco.com/warp/public/707/ios_804.html
Basically the one router without a set peer (the main site) will have a dynamic crypto (route) map like so. crypto dynamic-map rtpmap 10 set transform-set rtpset match address 115 crypto map rtptrans 10 ipsec-isakmp dynamic rtpmap I may be wrong but I dont think that this gets anything into the routing tables. You could probably add a static route that points to the interface where the map is. The packets would get the the router and pack their bags and get on board the crypto airplane and travel the vpn skys. I hope that helps and is true because I just made it all up. Ben --- jdr wrote: > Hello, > I'm sorry for ask this stupid question, but I can't > find a answer > > > I'm working on this scenario: > > LAN-to-LAN ipsec conections, hub and spoke topology. > A central site with a 7100 router,10 remote sites > with 806 routers (ADSL or > cable connections). > > > 1.1.1.0-- (7100 Router)- 11.1.1.1 ------- INTERNET > ---------- X.X.X.X > (806 Router)-- 2.2.2.0 > > | > > | > > - > --------- Y.Y.Y.Y (806 Router)-- 2.2.3.0 > > > My problem is that the 806 public IPs are dynamic > and it can change every > time that the 806 router restart. > > If the remote site IPs are dynamic, how do I can > route the traffic from the > central site to the branch ofices? > > I can configure the central router to accept dynamic > connections with a > preshared Key (for example), but Idon't know > configure the central site to > reach the private LANs of the remotes sites after > the connections are up. > > The CISCO examples always use a route to the remote > LAN through the public > IP (X.X.X.X) of the remote sites, but I can't use it > on this scenario > because it could change . > > > Thank you for your help and your patience (as I tell > you it was a stupid > question). > > > > Juan [EMAIL PROTECTED] __________________________________________________ Yahoo! - We Remember 9-11: A tribute to the more than 3,000 lives lost http://dir.remember.yahoo.com/tribute Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=53043&t=53028 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
