Hey, upgrade the OS on the switch to 6.3.6 / 7.2.1 or higher and you should be fine. Check out the last section of this url:
http://www.cisco.com/warp/customer/473/62.shtml dayo --- Creighton Bill-BCREIGH1 wrote: > Can we see your running config for the HSRP group > setup? > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED]] > Sent: Wednesday, November 20, 2002 9:38 AM > To: [EMAIL PROTECTED] > Subject: HSRP - Cat4006 stuck in INIT state > [7:57771] > > > Trying to test HSRP between 2 Cat4006s running IOS > 12.1(8a)EW1. > > 'Sho standby brief' says that the vlan routing never > gets switched over to > standy router and stays in the "INIT" state. > > Rtr 1 is standby for VLAN2 > Rtr 2 is active for VLAN2 > > perform a shutdown on interface VLAN2 on rtr 2; > > 'sho stand brief' gives no ip addresses for active > and standby rtrs., but > instead both say "INIT". > > Any ideas? > > tia, > Mary [EMAIL PROTECTED] __________________________________________________ Do you Yahoo!? Yahoo! Web Hosting - Let the expert host your site http://webhosting.yahoo.com Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=57790&t=57771 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
