That is the LILO problem what you are experiencing. Try to boot form CD or rescue floppy with the parameter root=/dev/hda1 (supposing your root partition is installed on /dev/hda1 or change this parameter to appropriate one) and check what's going on in the /etc/lilo.conf file Correct the errors there, check if the boot and root partitions are the right ones, run /sbin/lilo and reboot. Be sure you have connected your HDD cables in the right way and remember: Primary master=/dev/hda, Primary slave=/dev/hdb, Secondary master=/dev/hdc, Secondary slave=/dev/hdd and no other way. I guess the problem can be hidden somewhere in the incorrect hard disk or partition identification.
Good luck Ray
Pete wrote:
Hi Gang :
I installed a couple IPCop's already so I am a bit familiar with the setup process.
But yesterday I ran into an issue. After I completed the install -and rebooted the PC-
things came to a HALT.
I tried 3 different harddisks, played a bit with bios settings but no luck so far.
The last line on the screen, right after the bios messages (mem, hd etc) is
LI_
... Li underscore ... anybody ?
Its an older PII that worked just fine before I tried IPCop on it.
TIA
Peter
_______________________________________________ clug-talk mailing list [EMAIL PROTECTED] http://clug.ca/mailman/listinfo/clug-talk_clug.ca
_______________________________________________ clug-talk mailing list [EMAIL PROTECTED] http://clug.ca/mailman/listinfo/clug-talk_clug.ca
