Hi Bill
Rough cut the new material with an allowance of say 3/8" all around,
then using the original screw holes in the old floorboards screw the old
boards to the new and use a trimming bit in a router (straight bit with
bearing of the same diameter) to trim. No clamps required, and you use
the same screw holes to install the new boards.
+1 on the suggestion to ensure you line up the holly carefully from
panel to panel, I did not do this and it bugs me... but not enough for a
do-over!
Graham Collins
Secret Plans
C&C 35-III #11
On 2013-11-07 10:26 PM, [email protected] wrote:
I am planning to remake floorboards this winter. I have old ones for
pattern. Would be interested in any tips, on or off list, that anyone
has for patterning, cutting, finishing. Plan to epoxy all sides, then
varnish. Thinking of m making full size masonite patterns , attach
with double sided tape to new floor stock, then use straight cutting
bit in router to cut. Thoughts welcome.
Bill Walker
36
Pentwater, Mi
Sent from my HTC
----- Reply message -----
From: [email protected]
To: <[email protected]>
Subject: Stus-List Current C&C History; now a Dose of reality !!!!
Date: Thu, Nov 7, 2013 9:03 PM
_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
[email protected]
_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
[email protected]
_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
[email protected]
