It seems like you guys are on the right track.
Getting the holly seams lined up makes the finished product look
better. If the existing floorboards are lined up to your satisfaction,
put a few marks on your pattern where the holly strips are. Line these
up with your new stock and you should be in good shape.
If not, bring the patterns to the boat, put them in place and figure out
where you want the strips running. It's even harder than hanging a
picture straight!
Epoxy is your friend. Read the West Manual about flow coating. You
will use WAY more epoxy than you think.
Probably the most common mistake is forgetting to epoxy the screw
holes. Drill 'em, fit 'em and then over drill them just a tad and fill
with epoxy. Then drill 'em again.
--
Will Harris
Waterline Systems
716-531-6088
_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
[email protected]
