Still available? Be very glad to have it. Just let me know the particulars.
Neil Andersen 1982 C&C 32, FoxFire Worton Creek, MD On Thu, Nov 21, 2013 at 9:01 AM, Gary Nylander <gnylan...@atlanticbb.net>wrote: > I have a Datamarine Link 5100 system - appears to be complete. Came from > my SO's late sister - must have been taken out before they upgraded and > embarked on a voyage south. > > Datamarine 5100 control head, Display unit with digital speed and depth, > analog wind; DX111 depth, SX 120 speed, wind speed/direction mast top unit, > coax cable, through hull speed and depth sensors.... > > Yours for the cost of shipping, I have no need. > > Gary Nylander > Maryland > > > > ----- Original Message ----- > *From:* Robert Abbott <robertabb...@eastlink.ca> > *To:* cnc-list@cnc-list.com > *Sent:* Wednesday, November 20, 2013 9:13 AM > *Subject:* Stus-List Muffler > > John: > > I replaced the SS muffler this past Spring.....don't remember the exact > measurements put similar to yours. > > I replaced it with a Vernalift resin muffler....slightly bigger (2" > higher) muffler but with the same 2" inlet and 1 1/2" outlet. I will try > to find my receipt which will have the part # if that helps you. Bottom > line, Vernalift makes a resin muffler with a 1/1/2" outlet. I didn't want > to get into adding hose adapters as my exhaust hoes was replaced last year > and it is 1 1/2". There are no back pressure issues to worry about with > the 1 1/2" outlet with these small marine diesel engines. > > Bob Abbott > AZURA > C&C 32 - 84 > Halifax, N.S. > > > > > > > > > On 2013/11/20 9:00 AM, John and Maryann Read wrote: > > The stainless muffler has finally given up the ghost. It is 6 ¼ round, > 2 inch side inlet and 1 ½ inch top outlet, 9 inches high and the base is 7 > inches square. Any suggested sources?? Vernalift by Centek Industries > makes a close copy but the outlet is 2 inch. On a related note, any > thoughts on why the outlet is smaller than the inlet and does this create > any backpressure issues?? The engine outlet is 2 inch. On the other hand, > this set up has worked well for 30 years so it can’t be all bad J > > TIA > > John and Maryann > > Legacy III > > 1982 C&C 34 > > Noank, CT > > > > _______________________________________________ > This List is provided by the C&C Photo > Albumhttp://www.cncphotoalbum.comcnc-l...@cnc-list.com > > > ------------------------------ > > _______________________________________________ > This List is provided by the C&C Photo Album > http://www.cncphotoalbum.com > CnC-List@cnc-list.com > > > _______________________________________________ > This List is provided by the C&C Photo Album > http://www.cncphotoalbum.com > CnC-List@cnc-list.com > >
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com
