are all you guys talking about the yanmar 3gm30f engine?
Gary Kolc
---- Wally Bryant <[email protected]> wrote:
> Absolutely. I think that hours of heat on that hose/mixer elbow
> connection makes it impossible to remove without cutting it off. I keep
> a section of 2" exhaust hose stuck in the back of the boat, just in case
> I need to do it again. Maybe next time I'll try some Permatex #2 gasket
> sealant, which handles extended high temps without getting crusty.
> There's always something new to try and figure out.
>
> Wal
>
> John Russo wrote:
> > The hardest part was the short hose interfacing
> > the elbow with the muffler and I had a problem removing and reconnecting.
> > There doesn't appear to be any short cuts unless you are willing to cut off
> > the interface hose and replace it with a new one.
>
>
> _______________________________________________
> This List is provided by the C&C Photo Album
> http://www.cncphotoalbum.com
> [email protected]
_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
[email protected]
