Gary:
Sure, please send me the pictures offline.....email address....
[email protected]
I think I know what it looks like, and if I had done it that way, it
would have been a lot easier....but I didn't think of it that way at the
time.....I thought, a piece of 18" hose came off and an 18" hose is
going back on ...and it did but it was not easy.
Rob
On 2014/01/25 3:45 PM, [email protected] wrote:
The U elbow piece is ID threaded and on my setup there is a 2" piece of standard black
pipe threaded into it. Next is a 90 degree elbow then a 3" piece of pipe. That 3"
piece of pipe has been turned down from an OD of 1 .650 to 1.520. This piece is turned about
1.5 inches back. This allows the hose to the water muffler to slide on easily. Even after 20
years I was able to undo the 2 clamps and slide the assembly off with no trouble. Pictures
available.
Gary
---- Jake Brodersen <[email protected]> wrote:
Looks just like mine.
Jake
-----Original Message-----
From: CnC-List [mailto:[email protected]] On Behalf Of
[email protected]
Sent: Saturday, January 25, 2014 2:11 PM
To: [email protected]
Subject: Re: Stus-List Mixing Elbow
is this the mixing elbow everybody has?
http://www.oldportmarine.com/misc_gm_ym_uelbow_assy.htm
Gary
_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
[email protected]
_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
[email protected]
_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
[email protected]
