Should have channeled John Holmes to keep it stiff. Jim Watts Paradigm Shift C&C 35 Mk III Victoria, BC
On 27 January 2014 16:28, Wally Bryant <[email protected]> wrote: > Yeah, be careful. All rudder bearings are not created equal. On my last > boat, I just put a grease gun on the zirc fitting and pumped until grease > squirted out on the top and bottom. > > On this boat that created a problem. <http://www.wbryant.com/ > StellaBoat/Projects/steering/zerk/zerk.htm> I actually haven't looked at > that page in years, and find it quite funny. > > And, by the way, I haven't squirted grease in there since. It's been ten > years, and the rudder has been worked pretty hard. Last haul out I > resurrected Bruce Lee to give it a good kick, and Marilyn Chambers to give > it a good wiggle. No problems. > > Wal > > Rick Brass wrote: > >> <snip> there has been frequent discussion on >> >> the list over the years about changing out the grease cup in favor of a >> zerk >> fitting or long hose with zerk to facilitate greasing and what grease >> works >> best. <snip> >> > > > _______________________________________________ > This List is provided by the C&C Photo Album > http://www.cncphotoalbum.com > [email protected] >
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com [email protected]
