Mike:
Not sure I would use 1/2" T&H vs. 3/4" because it is available locally.
Your Micron 66 wasn't available locally and look at your level of
effort to get 'a one timer' versus your cabin sole for as long as you
own and enjoy Persistence.
Bite the bullet and order the 3/4" T&H and do it right.
PS: I was at the boat yesterday....my first Spring project will be to
go back this week with my axe and shovel to remove the 'glacier' where I
place my step ladder to board. Don't think I am going 'splash' just yet.
Rob Abbott
AZURA
C&C 32 - 84
Halifax, N.S.
On 2015-04-14 1:30 PM, Hoyt, Mike via CnC-List wrote:
We are looking to replace the cabin sole in our Frers 33 this season. It is
comprised of horizontal floors and covered by 3/4 inch teak and holly. This is
very likely the same as many C&Cs.
To date I can source 1/2 inch Teak and Holly locally but there is no stock and
no known reorder date for 3/4 inch. The two sources in Halifax are East Coast
Specialty Hardwood who have 1/4 and 1/2 inch in stock and are out of stock on
3/4 and Halifax Specialty Hardwoods who only stock 1/4 and 1/2 inch.
This leaves me to try one of three options:
1- Source out of town 3/4 T&H and pay for the shipping of a 78 lb piece of 4x8
plywood.
2- Use 1/2 inch in place of 3/4
3- Laminate 1/4 inch on top of 1/2 inch marine plywood.
And the always available 4th option. Procrastinate and do this next year
Does anyone have any thoughts on this or know of other suppliers near Halifax?
Regards
Mike Hoyt
1987 Frers 33
Persistence
Halifax, NS
_______________________________________________
Email address:
[email protected]
To change your list preferences, including unsubscribing -- go to the bottom of
page at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________
Email address:
[email protected]
To change your list preferences, including unsubscribing -- go to the bottom of
page at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
